Page 1 of 1
HR2510 bias adjustment
Posted: Tuesday 9th Sep 2008, 13:14
by captian_radio
I just got an old HR2510 and was checking it over to make sure it is ok.When checking the bias on the driver and final I notice that it is almost impossible to set the bias to 50ma on the driver, seems to be erratic, I cleaned up the VR but its still the same, the final is bang on just the driver seems to be so touchy, any ideas?
Tnx Bob
Posted: Friday 19th Sep 2008, 11:08
by captian_radio
Anyone,can't be that tough a question.
Bob
Posted: Monday 13th Oct 2008, 2:02
by captian_radio
Must not be any 2510 users out there, will swap out the VR and and see what happens.
Bob
htx 100 and 2510 and 2600
Posted: Thursday 23rd Oct 2008, 13:11
by hamguy2
hi so you know if you stick a pair of mrf477s in them theyll do 100 watts ssb easy same as the htx 100 same chip. but its not all mode you can put lsb back in the htx 100 also am etc but a fair bit of work needed ,thanks hamguy2 nsw australia
Posted: Friday 24th Oct 2008, 1:49
by captian_radio
Tnx for the info but I am not interested in getting more power at this time and the Rogerbirds site has a comprehensive review with mods etc, lots of good info there.Basically just going to use the 2510 as a back up for my other mobile rig.
Bob